using the attached image as the base reference keep the overall composition camera angle lighting materials and layout exactly as shown apply only the following corrections drawer column width narrow the 4 drawer column currently under the induction cooktop so it matches the width of the induction module directly above it the drawers currently read as too wide bulky compared to the rest of the cabinet grid make them flush and proportionally aligned with the neighboring 50 cm sink cabinet and the tall column on the right not wider than either microwave fully black change the built in combi microwave so it is entirely black black glass door black frame black control panel remove the stainless steel silver trim strip currently visible around the microwave door keep only a small black siemens logo no metallic accents anywhere on the appliance right side of tall cabinet column remove the narrow vertical corner filler trim strip currently visible on the right edge of the tall unit fridge microwave column that column should end as a single clean flat panel flush with no extra corner piece or divider strip keep everything else unchanged dark wenge wood grain fronts black countertop black glass backsplash behind the cooktop only thin black rail handles white matte wall neutral daylight lighting concrete floor negative prompt no stainless steel or silver on the microwave no wide oversized drawers no extra corner trim panel on the right side of the tall column no changes to cabinet layout appliance positions lighting or camera angle
